Hello, Jo here again this month! I will apologise in advance for the number
of wedding related posts you are going to see from me in the coming months. My little brother finally tied the knot in
December and I was lucky enough to be asked to do the little things that add to
a special day like the invitations, wishing well etc. My little girl was blessed with being one of
the flower girls along with my two beautiful nieces. So, as you can imagine I have a HUGE pile of
photographs waiting to be scrapped.
However, today I thought I would show you
the Wishing
Well as it’s raw version is a Molossi
product If you have a wedding coming up or perhaps you make invitations for
people as a little business and wish to hire out a well – this could be right
up your alley!
The wishing well is laser cut from 12mm MDF
and stands 80cm high. The actual box
part of the well is 40cm wide and 30cm high.
When you receive the well it comes in 8 flat packed pieces. It is really easy to assemble and in fact I
decorated mine in pieces and transported it flat from Qld to NSW for the
wedding as I didn’t have a great deal of room in my car. I simply put it together the night before the
wedding by tapping the lugs into the correct holes. To transport it home I simply pulled it apart
and brought it home flat packed also J You can glue it for extra strength but I
found this really wasn’t necessary. It
is a very sturdy well and at no stage has it ever looked like it might
separate.
Now I’m blessed with a husband who is a
spray painter, so I took the raw pieces to him and had him spray them and clear
coat them in 2pac car paint! I knew that
no amount of knocking around en-route to the wedding would damage them this way
and I simply wrapped the pieces in cloth to avoid any scratches. However, the edges are black due to the laser
cutting and it takes more than a fine mist of paint to cover this. Out came my trusty Adirondack acrylic paints
( I found a pearl colour which was an exact match to the white pearl paint
hubby had used) and two coats with a paint brush on the edges and all was
covered perfectly. As the paint was
pearlised and therefore had a sheen of it’s own and it was just the edges, I haven’t bothered with any clear lacquer
over the top. However, if you don’t have access to a painter friend
and are doing the whole project in acrylic paint I would suggest you then cover
in a clear gloss to give your well a shine and protect the paint.
I then ran a fine line of Helmar 450 glue
(this stuff sticks ANYTHING) along the edges of the well and added some sticky
bling runners also from Molossi.
These runners come in a huge range of colours and even pearl runners –
check out this link to see all of them . Now whilst these are self adhesive, I found
that without a bit of added adhesive help the heat affected them and they
peeled off. A quick touch of glue
beneath them and they are there for life.
My final touches was simply a piece of
ribbon in the bride’s colour scheme to complete the look.
Simply change the colour of the ribbon and
perhaps place the bride’s bouquet on the table beside it back at the reception
and you have a whole new look.
The lid with the slit in it lifts easily on
and off the box allowing you to remove the cards left there by guests at the
end of the evening.
If you do have an upcoming wedding, I urge
you to pop over to the Molossi shop and check out the huge array of products
that will help make that special day even more special.
I’m just waiting on the official photographs to come back so I
can share more of the wonderful Molossi MDF goodies with you – stay tuned.
